You can end up with gaps on the underside where they are not visible from above. For a bit of fun this afternoon I thought I would have a go at tuning up the car and trying to get it running smoothly and idling well. Send us a message. Or, doing the opposite, leaving mix where I think is about right and pulling out choke also causes it to flood and bog down. Lawrence, yeah, I really should buy a compression tester one of these days Hi Malcolm Can you do the test again, slowly increase throttle opening and record vac readings up to say rpm? But l wouldn't worry about it.
Japanese Mini K-Truck & Mitsubishi Jeep Parts Since
MG Midget and Sprite Technical 79 Midget 1500 idle speed BBS discussion at MG-Cars.net
Jim Shelton, 41, Shelton-NT. Yokohama Motors Main Website. Aric Gentry, 10, Gentry-NT; Fast idle screws are also not fouling the cold start mechanism correct clearance and I have pushed down on the throttle linkage to take care of an old and knackered throttle return spring which I will replace anyway later this week. Don't think it can be fixed
In , Morris became a member of England's House of Lords. I remember a post by Tom Bedenbaugh where he said he sets Bs to idle at rpm. Simple high-speed bypass circuit used for trimming the fuel curve in mechanical fuel injection. One set is for the throttle body or hat if so equipped , and the other set is for the manifold ports.
Even if he had the seat for the needles to low it wouldnt pull the gas in! I'd also say it sounds like an air leak, but only because it takes so long to get back to idle revs. Alex I noticed that as well Of the plugs that are there the Lh one looks dodgey to me--glazed up on the insulator- David Billington. I would be happy to discuss on a new thread if you like? I don't know if that answers you question, but I tried! Just wire brush them.